Weather
Searchby chance,i found that the sealine x shv/sha can be upgraded like a grandwave z,5 ball bearings and infinite anti reverse compare to 3 ball bearings and no infinite....and 2 different size ball bearing
1st of all,you need to order the following 4 parts from DAIWA and they are
1)6F827801(handle metal plate)
2)6E248101(handle metal plate screw)
3)6F827101(collar D)
4)6F827601(handle metal)
2nd,get 2 ball bearings of different locally and you are ready to transform your SHV/SHA into a GRANDWAVE Z!!!!
just following the steps and you should be able to modify your own reel.....
THESE ARE THE TOOLS YOU NEED AND PARTS FROM DAIWA
A CLOSED UP LOOK ON THE PARTS FROM DAIWA
UNSCREW THE HANDLE NUT SCREW
REMOVE THE HANDLE NUT WITH THE SPECIAL TOOL FROM DAIWA
TURN OUT THE STAR DRAG(ANTI CLOCKWISE)
TAKE OUT THE DRAG CLICKER,DRAG SPRING WASHERS,BEARING WASHER AND BEARING IN ORDER
REMOVE ALL 6 SCREWS FROM THE END PLATE
THIS IS HOW THE INTERNAL SHOULD LOOK AFTER YOUHAVE OPEN IT
WE ARE GOING TO REPLACE THE BUSHING WITH A BEARING
BEARING VS BUSHING
USE A SMALL SCREWDRIVER TO REMOVE THE RETAINER,BECAREFUL AS THE RETAINER CAN REALLY FLY!!
AFTER THE RETAINER HAD BEEN REMOVE,TURN OVER,REMOVE THE CASTING CAP,TAKE OUT THE PINION SHAFT AND PUSH OUT THE BUSHING USING A SCREWDRIVER
SLOT IN THE BEARING AND PUT BACK THE RETAINER,MAKE SURE ALL 4 CORNERS ARE SITTED IN THE SLOT
PUT BACK THE PINION SHAFT AND CLOSE BACK THE CASTING CAP
NEXT IS THE INFINITE ANTI REVERSE,SLOT IN THE HANDLE METAL AND TURN SLIGHTLY,IT WILL SIT NICELY INTO THE GAP
PLACE THE HANDLE METAL PLATE OVER THE HANDLE METAL AND TIGHTEN WITH THE SMALL SCREW
NEXT,REPLACE THE ORGINAL COLLAR D WITH THE ONE FROM GRANDWAVE Z AND IT SHOULD SLOT INTO THE DRIVESHAFT WITH THE GAP FACING THE FRAME AND THERE SHOULD BE NO GAP IN BETWEEN
TIME TO CLOSE IT,MAKE SURE THAT THE PINION SHAFT SLOT INTO THE PINION GEAR AND THE CLUTCH CAM CATCHES THE YOKE PLATE,AFTER THAT GIVE THE CLUTCH LEVER A FEW PUSH JUST TO CONFIRM THAT THE ARM SIT IN THE YOKE PLATE
PUT EVERYTHING BACK IN ORDER
LOCK BACK THE 6 SCREWS AND THE 2 LONG ONE SHOULD BE AT THE BOTTOM
PUT THE HANDLE BACK AND TIGHTEN THE HANDLE NUT AND STOP WHEN THE GROOVE OF THE NUT IS IN LINE WITH THE HOLE,FINALLY TIGHTEN THE HANDLE NUT SCREW
A UPGRADED SHA
THE 3 MUSKETEERS OF DAIWA
DAIWA GRANDWAVE Z 30 SHW
DAIWA SEALINE X 30 SHA
DAIWA SEALINE X 30 SHV
Last edited by Derrick Lim on Fri Jun 20, 2008 9:36 pm; edited 4 times in total
- Once a Surfcasting Jedi, always a Surfcasting Jedi, but will fly too
